Editing Jail Server Install (section)

== Install OS (sysinstall) ==

boot to bootonly disk for AMD version of FreeBSD, i.e. <tt>FreeBSD-8.3-RELEASE-amd64-bootonly.iso</tt>

when the install menu appears, choose <tt>custom install</tt>

=== partition menu ===
move cursor to mfid0, hit space (takes you to partition map screen). If there is only 1 mirror, there will be no option to select a specifit drive: mfid0 will be selected.

type 'a' to use entire disk<br>
type 'q' to quit and save<br>
choose 'freebsd standard mbr'

space to '''un'''select mfid0<br>
cursor down to mfid1<br>
hit space

type 'a' to use entire disk<br>
type 'q' to quit and save<br>
choose 'none' for boot mgr (leave untouched)

cursor over mfid0<br>
space<br>
(takes you into part. Screen again) 'q' to exit<br>
none for boot mgr<br>

Make sure both drives (mfid0 and mfid1) are checked and tab to ok

=== Label menu ===

Make sure mfid0 is highlighted at the top of the screen, setup the following partitions

/ 512M<br>
swap 6G<br>
/var 256M <br>
/tmp 256M<br>
/usr 5G<br>
/mnt/data1 remaining space 

All partitions except / should be setup for soft updates. If not, type 's' to enable for soft updates on all except for / (should look like UFS2+S Y under the Newfs column)

move cursor to mfid1 at the top of the screen<br>
swap 8G (or 4G if there’s a 3rd drive)<br>
/mnt/data2 remaining space <br>
'q' to save and exit

=== distributions ===
Choose the following distribudions

* developer (ok to install ports)
* custom -> lib32
exit

=== media ===
if you are installing via a cd, no need to enter this menu or change anything. Otherwise, choose ftp to install via ftp. You will be prompted to setup networking. You will need to choose a nic (typically bce0 or bce1). Say no to DHCP and IPv6. Hopefully the public nic cable was installed in bce0 so start with that nic and provide the hostname, (public) IP, netmask, gateway and DNS. When configured, it should start pinging. If it doesn't, have the NOC swap cables. Select any FTP server, usually Main or ftp4.

=== commit ===

this usually takes 12mins<br>
during the process you may need to select a new ftp mirror, this is not a problem.<br>
at the conclution of the install you will be prompted to enter the root password (2x) and returned to the configuration menu.

=== add user ===

'''Add''' user 'user'. Defaults for everything is fine, just remember to enter 'wheel' in the member group field.
Do set the password.

=== Setup timezone ===

PT

=== Networking === 
page down to the bottom and enable '[X]' sshd

If you installed via cd, you will need to visit:<br>
interfaces->bce0-><br>
No IPV6<br>
dhcp=no<br>
Set hostname, IP, DNS, gateway<br>
(i.e. setup the nic as indicated above)


Exit the install and if you installed via CD, take it out and let the machine reboot