Editing RAID Cards (section)

== CLI (9xxx) ==
=== Replacing a failed drive ===


<pre>
tw_cli /c0 show all

Port   Status           Unit   Size        Blocks        Serial
---------------------------------------------------------------
p0     OK               u0     1.82 TB     3907029168    WD-WCAVY0647904
p1     OK               u0     1.82 TB     3907029168    WD-WCAVY0608298
p2     OK               u1     1.82 TB     3907029168    WD-WCAVY0629856
p3     OK               u1     1.82 TB     3907029168    WD-WCAVY0627316
p4     OK               -      1.82 TB     3907029168    WD-WCAVY0564054
</pre>

then you should run:

<pre>
tw_cli /c0 rescan
tw_cli /c0 show all

Port   Status           Unit   Size        Blocks        Serial
---------------------------------------------------------------
p0     OK               u0     1.82 TB     3907029168    WD-WCAVY0647904
p1     OK               u0     1.82 TB     3907029168    WD-WCAVY0608298
p2     OK               u1     1.82 TB     3907029168    WD-WCAVY0629856
p3     OK               u1     1.82 TB     3907029168    WD-WCAVY0627316
p4     DEGRADED         u1     1.82 TB     3907029168    WD-WCAVY0564054
</pre>

and the array should show that it is rebuilding

BUT, if you attempt to rebuild with a command like that, and you get:

Error: The following drive(s) cannot be used [4].

you need to remove it, then rescan, then rebuild:

 tw_cli /c0/p4 remove
 tw_cli /c0 rescan
 tw_cli /c0/u0 start rebuild disk=4